Žilinská univerzita v Žiline

Permanent URI for this communityhttps://drepo.uniza.sk/handle/hdluniza/1

Browse

Filters

20232

Settings

Author: search.filters.author.Matejka, MarekSubject: search.filters.subject.HPDC

Search Results

Now showing 1 - 2 of 2
  • Thumbnail Image
    Item
    Hodnotenie vplyvu technologických parametrov na mikroštrutúru vysokotlakových odliatkov
    (Žilinská univerzita v Žiline, 2023) Medňanský, Martin; Brůna, Marek; Matejka, Marek
    A number of technological parameters influence the mechanical properties of a high pressure die casting. The aim of the presented paper was to perform microstructural analysis of AlSi9Cu3(Fe) alloy casting fabricated with high-pressure die casting (HPDC) technology. Several castings with varying casting parameter – maximum plunger speed vmax were cast. In pre-selected critical spots, the effect of vmax was observed on the shape and size of the structural components, where at lower vmax the eutectic Si shortened in length and thickened. EDS analysis determined found intermetallic phases to be α-Al(Fe,Mn,Cr)Si in the shape of a rhombic dodecahedron with sizes as small as 2 µm and Al2Cu being present in both modifications – oblong grains and globular ternary eutectic. There was no significant change in microhardness of α(Al) phase found, that would be caused by the varying vmax
  • Thumbnail Image
    Item
    Štruktúra hliníkových zliatin pre vysokotlakové odlievanie
    (University of Žilina, 2023) Medňanský, Martin; Brůna, Marek; Matejka, Marek
    The aim of the presented paper was to carry out a review of the internal structure of alloys used for high pressure die casting (HPDC) and to experimentally perform a structural analysis of AlSi9Cu3(Fe) alloy. Several castings with varying casting parameter – maximum plunger speed vmax were cast. In pre-selected critical locations, a change in porosity was observed with the change of the speed, and the casting samples with vmax = 2 and 3 m∙s-1 showed the lowest porosity. The effect of vmax was also observed on the shape and size of the structural components, where at higher vmax the eutectic Si grew in length and decreased in thickness. EDS analysis determined found intermetallic phases to be α-Al(Fe,Mn,Cr)Si in the shape of a rhombic dodecahedron with sizes as small as 2 µm and Al2Cu occurring in both modifications – oblong grains and globular ternary eutectic.